Santhuff Steel Body Strut & Front Shock Adjustment Procedure
- Set strut shock in vertical position
- Turn top adjustable 3/8" hex nut clockwise until nut stops.
- Turn top adjustable nut counter-clockwise 3 turns.
- If double adjustable, turn lower bump adjuster hex knob fully clockwise. Then turn out counter-clockwise 10 clicks.*
- Stroke strut shock 5 or 6 times to prime the valving and avoid cavitation (After laying horizontal the fluid is displaced).
- Turn top adjustable nut fully clockwise until nut stops again. At that position the strut shock is at it's full firm rebound (extension) position.
- Turn lower bump adjuster hex knob clockwise until it stops to bring it back to the full firm (compression) position.
- The strut shock is at it's softest position on extension when the top adjustable nut is turned 3 1/4 turns counterclockwise. O-ring damage could occur if turned any more than 3 1/4 turns.
- The strut shock is at it's softest on the bump (compression) when the adjuster hex knob is turned counter-clockwise till it stops.**
Baseline Setting for Struts and Front Shocks on Drag Radial Cars
The following adjustments are based with all sweeps or clicks starting from a full tight adjustment (clockwise) position. Start the fronts set at 1 turn or 6 sweeps on the rebound adjustment and 6 clicks on the compression setting.
Steel Body Strut & Front Shock Baseline Settings
|Cars Horsepower||On Top (extension)||Bottom (compression)|
|3000 HP||1/2 turn||10 clicks|
|2000 HP||1 turn||8 clicks|
|1500 HP||1 1/2 turn||6-7 clicks|
|1000 HP||2 turns||6 clicks|
|500 HP||3 turns||5 clicks|
*Bump is same as a single adjustable shock at 10 clicks from full tight
**If trying to delay return of front weight transfer start at 6 clicks from full tight. 6 or 7 clicks is also a good tight adjustment to use for a car that wheelstands violently and may help save your headers.
Printed from https://www.santhuffshocks.com
12886 County Road 1394
Sinton, Texas 78387